Basement Waterproofing

Basement waterproofing involves the use of various techniques and materials to prevent water from penetrating into the home. This process involves sealing water-resistant materials and preventing the entry of water below and above ground levels. Depending on your needs, you may need to install new reinforcements in the foundation or use interior floor drain systems. Read on to learn more about the different options available to you. Below are some of the advantages of basement waterproofing.

Interior waterproofing

A home’s foundation is not the only culprit when it comes to water in the basement. Poorly installed gutters, uneven slopes, and leaking water pipes can also cause moisture issues. Even a “dry” basement can suffer from excessive humidity. To stop water before it gets to your basement, you need to waterproof it. In addition to waterproofing the foundation wall, you should protect the floor with a drainage board. If you have any questions about waterproofing your basement, consider hiring a professional company to do it for you.

There are several methods of interior waterproofing for basements, including a subgrade drainage system. These methods typically involve a 4″ drainage pipe, dimpled drainage matting in the cove joint, river wash gravel in the drainage trench, and a sump pump with basin. Some homeowners choose to install these systems on their own, but the installation can be tricky if you’re not familiar with plumbing. If you’re handy with tools, you can hire a professional for this job.

Foundation crack injections

Epoxy and polyurethane are two types of injections used for foundation cracks. Both types of these materials can be injected under low or high pressure. These injections contain two components: epoxy resin and hardener. Once cured, these materials create a stronger bond between the wall and the crack. This method is effective for small and moderate cracks, and it has the benefit of being more durable than traditional methods.

Crack injections can be applied by a professional contractor or a do-it-yourself homeowner. These procedures can be accomplished in an hour or less. While these repairs can be expensive, they can also be a good choice for homeowners that do not want to hire a contractor. Fortunately, a crack injection for basement waterproofing is a do-it-yourself project that can be done by a home owner.

Interior floor drain system

You should check the interior floor drainage system of your basement before putting in the waterproofing system. There are ports on the floor where you can look inside the system. Using a shop vacuum hose can minimize dust from the drilling process. If the interior floor drainage system needs to be replaced, you should consult a professional basement waterproofing company. In addition to assessing and cleaning the interior floor drain system, a basement waterproofing expert can also provide you with the proper materials.

French drains are another type of interior floor drainage system. They are installed next to the footer of the basement and slope down to a drainage point, usually a sump pump system. To ensure that the drain is effective, at least a 1/2 inch fall is required for every 10 feet of drainage pipe. An interior footer drain may not be the best option if your basement has wet walls. If you have a concrete floor, an exterior basement waterproofing system might be more appropriate.

New build reinforced concrete

The most common method for basement waterproofing is using asphalt tanking. It is most appropriate when the subsoil water table is not too high. Asphalt tanking consists of horizontal DPC that is 30 mm thick applied in three coats over the entire basement floor, as well as on the outside walls of the basement. The DPC is applied 15 cm above the ground level, and protective flooring is provided during the construction.

If water penetrates a concrete wall, it will dissolve the salts in the wall. As water seeps into the concrete wall, it continues its journey to the basement. When the surface dries, the water evaporates and the salt deposits remain. This is a common symptom of water penetration. Waterproofing is a necessary step for protecting a home’s foundation. If it isn’t done properly, the walls can develop cracks, leaks, and damage to the interior.